DOD SR400D Especificaciones descargar pdf (Pagina 84)

PRE-START PROCEDURES

 4. Check the fuel level in the gasoline tank. Fill the

tank as needed with unleaded gasoline mixed with

two-cycle oil at a ratio of 2.6 ounces of oil mixed in

1 gallon of gasoline.

 5. Slide the Stop switch (Fig. 30) to I “UP” located on

the rear of the control handle. Move the setting

lever (left side of handle) (Fig. 31) to the center

position. STARTING THROTTLE POSITION.

 6. If the engine is COLD, turn the choke knob to I

choke “UP” located above the starter rope (Fig.

32). If the engine is ALREADY WARM, place the

choke knob down to the open position (Fig. 33).

START UP PROCEDURES

 7. Put the unit on the ground. Check that bystanders

are well clear of the general work area and the

nozzle. Make sure you have a firm footing.

CAUTION. HEARING PROTECTION REQUIRED.

 8. Hold the unit with your left hand on the housing

(Tank Top) and put one foot against the base plate

to prevent it from slipping. Pull the starter grip

slowly with your right hand until you feel it engage

and then give it a firm strong pull. (NOTE: Do not

pull the rope to its full extension as it might

otherwise break. Do not let the starter grip snap

back.)

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 243 244

Sin comentarios

DOD SR400D Especificaciones Pagina 84