DOD SR400D Especificaciones descargar pdf (Pagina 80)

 k. Rotate the pleated hose (Fig. 19-13) so the

marks are in the positions shown in the

illustration. With the pleated hose in this position,

make sure the control handle is vertical and

tighten it down firmly. Push the stub (Fig.20-14)

into the tank base. Fit the union nut (Fig. 20-2)

and screw it in tightly.

 l. Unscrew the hose clamps (Fig. 21-15) and

remove the bellows (Fig. 21-16) (hose clamps

are used again). Unscrew the tank cap. Pull the

strainer (Fig. 22-17) off of the hose (Fig. 22-18),

push the reducer (Fig. 23-19) out of the tank from

the inside and remove it together with the hose

(Fig. 23-18).

 m. Join up the two half-shells (Fig. 24-20) and

secure them to the tank and fan housing with the

hose clamps (Figs. 21-15, 24-15). [IMPORTANT

NOTE: The completed shell is larger in diameter

at the top compared to the bottom. Use the larger

hose clamp on top and the smaller hose clamp

on the bottom (Fig. 21-15, top and Fig. 21-15,

bottom.)]

1 2 ... 75 76 77 78 79 80 81 82 83 84 85 ... 243 244

Sin comentarios

DOD SR400D Especificaciones Pagina 80