DOD SR400D Especificaciones descargar pdf (Pagina 175)

167

 3. Check the engine oil level using the dipstick

located at the rear of the engine. Add SAE 30

weight detergent oil as needed.

 4. Check the blower oil level. The plug is located on

the side closest to the drain plug. Fill through the

breather plug at the top, until the oil runs out of the

overflow hole at the side of the blower; close with

the oil plug. You must use 40-weight NON-

DETERGENT oil as needed.

 5. Periodically grease the two fittings, located behind

the engine, with chassis grease on the blower.

 6. Check the battery water level. Add water to the

proper level. Periodically charge the battery.

 7. Ensure that the sprayer battery cables are clean

and tightly connected.

 8. Check the flushing solution level and fill the tank as

needed with an approved flushing solution. This

clear plastic tank has a one-gallon capacity and is

located behind the lab pump (gray box).

 9. Open the in-line gasoline control valve located

under the gasoline tank.

 10. Close the choke, located to the left of the fan

shroud and to the right of the air filter, by moving

the lever to the choke position (to the left). Omit

this step if the engine is already warm.

1 2 ... 170 171 172 173 174 175 176 177 178 179 180 ... 243 244

Sin comentarios

DOD SR400D Especificaciones Pagina 175