DOD SR400D Especificaciones descargar pdf (Pagina 193)

185

SPRAY OPERATING PROCEDURES

 9. Put on required PPE.

 10. Fill the pesticide tank with the required amount of

pesticide. Replace the tank cap, ensuring that the o-

ring is in place.

 11. Ensure the pesticide remote control valve is off or

the manual valve at the spray nozzle is closed.

 12. Restart engine and allow it to warm up. Set throttle

to achieve the desired air pressure (normally 60-90

PSI).

 13. Check for improper air pressure. Air pressure is

factory set with throttle control in FAST position. If

air pressure is incorrect, check for air leaks at all

joints between air pump and outlet of aerosol nozzle

assembly. Check for loose or slipping belts, ½”-

”

deflection. Check for proper engine RPM.

 14. Open the pesticide control valve toggle switch on

remote or manual valve at spray nozzle to start the

flow of pesticide. Flow Rates – The formulation flow

rate is controlled by a metering orifice located in the

fitting at the top of the formulation tank. To remove

or change an orifice disc, use two (2)

” wrenches

(one to hold the tank fitting, and the other to unscrew

filter/orifice chamber nuts). Note: It is easier if you

first remove the pesticide line at the tank fitting.

AIR PRESSURES

1 2 ... 188 189 190 191 192 193 194 195 196 197 198 ... 243 244

Sin comentarios

DOD SR400D Especificaciones Pagina 193