DOD SR400D Especificaciones descargar pdf (Pagina 200)

192

 4. Check the blower oil level. Add 40W non-detergent

oil.

 5. Check the battery water level. Add to the proper

level.

 6. Ensure that the sprayer battery cables are clean

and tightly connected.

 7. Check the belt tension by pressing down on the

belt between the engine and the compressor with

your finger. A properly maintained belt should

deflect between

and

inches. NEVER

ATTEMPT TO CHECK THE BELTS WHILE THE

ENGINE IS RUNNING.

 8. Check the flushing solution level and fill the

container as needed.

 9. Open the two gasoline control valves. One is

located underneath the gasoline tank and the other

is next to the carburetor.

 10. Close the choke located underneath the air filter.

(Omit this step if the engine is already warm.)

 11. Connect the multi-pronged connector to the digital

flow instrument panel. All switches on the

instrument panel should be in the "OFF" position.

 12. Set the bypass toggle switch, located on the

machine at the control module, to the "OFF"

position.

1 2 ... 195 196 197 198 199 200 201 202 203 204 205 ... 243 244

Sin comentarios

DOD SR400D Especificaciones Pagina 200