DOD SR400D Especificaciones descargar pdf (Pagina 181)

173

 11. Turn both switches located on the right side of the

flow control panel OFF, (i.e., light and fog switch).

Place the toggle switch located on the remote

operator's station in the center position.

 12. Put on all personal protective gear.

 13. Add the calculated amount of pesticide to the

insecticide tank located in the rack behind the flow

control panel. REMEMBER, ULV/ULD machines

use only concentrated liquid formulations.

 14. Place the toggle switch located at the rear of the

frame between the engine and blower in the ON

position.

 15. Push the starter button located next to the switch

for a maximum of 30 seconds, or until the engine

starts. CAUTION: HEARING PROTECTION

REQUIRED.

 16. As the engine warms up, slowly open the choke.

OPERATING PROCEDURES

 17. Check the blower pressure gauge, located on the

right side of the Constant Volume (CV) flow control

panel, by temporarily holding your finger over the

hole in the plastic fitting to the right of the air

gauge. Pressure should read 6 psi. If not,

readjust the engine RPM by turning the idle speed

adjusting screw, located on the left side of the

carburetor below the gas line.

1 2 ... 176 177 178 179 180 181 182 183 184 185 186 ... 243 244

Sin comentarios

DOD SR400D Especificaciones Pagina 181