DOD SR400D Especificaciones descargar pdf (Pagina 123)

115

 7. Grease the agitator shaft fitting located at the

agitator shaft flange at the rear of spray tank behind

the pulleys. Use multi-purpose lithium based grease

in a hand-operated gun.

 8. Unscrew and examine the in-line jar-type filter and

clean as needed. The filter housing is located on the

right side of the pump.

 9. Ensure that in-line valves located at the base of the

pump and on the right front part of the tank are in

the OFF position (handle is in cross-line position).

 10. Ensure that the pressure relief valve, located

adjacent to the pump dome, is backed out with the

handle up.

 11. Close the choke by moving the choke lever over to

the CHOKE CLOSE position (Omit this step if the

engine is already warm).

 12. On a cold engine: place the throttle control midway

between the slow and fast positions.

 13. Pull the starter rope firmly until the engine starts.

CAUTION: HEARING PROTECTION REQUIRED.

Return the rope in one smooth motion; DO NOT

LET GO OF THE ROPE!

 14. As the engine warms up, slowly open the choke.

 15. Put on all personal protective equipment (PPE).

1 2 ... 118 119 120 121 122 123 124 125 126 127 128 ... 243 244

Sin comentarios

DOD SR400D Especificaciones Pagina 123