DOD SR400D Especificaciones descargar pdf (Pagina 241)

233

located center of slide. “Off” position located on

right or left side of “Run” position.

 26. Drive shaft boots - Check drive shaft boots for

wear and tear. Insure clamps are installed. Front -

four (located front drive axles) rear – one (located

left rear of engine)

 27. Nuts, bolts, and fasteners - Check for loose nuts,

bolts, and fasteners (i.e., wheel lug nuts, shock

absorbers, cargo racks, etc.)

 28. Steering - check for proper side-to-side operation.

 29. Cargo/equipment - Make sure all cargo/equipment

is properly secured.

 30. Underbody - Check for/remove dirt, vegetation or

other debris that could be a potential fire hazard or

interfere with the proper operation of the vehicle.

 31. Air filter - Remove seat by releasing lever located

under seat left side. Remove air filter cover by

releasing 4 metal clamps. Inspect air filter and

clean as needed.

 32. Air cleaner case drain tube - The tube is a semi-

clear pink tube approximately 3 inches long

(located rear of the engine above the axle) look for

any debris that has collected in the bottom of the

tube. Remove and clean as needed.

1 2 ... 236 237 238 239 240 241 242 243 244

Sin comentarios

DOD SR400D Especificaciones Pagina 241