DOD SR400D Especificaciones descargar pdf (Pagina 172)

164

 31. With the unit spraying, check to make sure the

nozzle air pressure is within the preset pressure

range. The Clarke Grizzly Cold Aerosol Fog

Generator is preset at the factory at 6 psi. If a

different nozzle pressure is required, change the

engine speed by adjusting the engine throttle.

 32. To turn spray off:

 a. On the Remote Control Station, turn the spray off

by moving the spray switch to the OFF position.

The red light will go out and the engine speed will

reduce to idle.

 33. NOTE: On the initial start, it may take several

seconds for the insecticide to move from the

insecticide tank, fill the lines and start spraying. This

is normal.

FLUSHING

 34. It is absolutely necessary to use a flushing solution

that will cut your insecticide. Do NOT use diesel oil

as a flushing solution.

 35. It is a simple matter to flush the system as follows:

 a. If the engine is not running, start the engine as

explained in the START-UP section.

 b. On the Remote Control Station, set Select

Spray/Flush switch to FLUSH.

1 2 ... 167 168 169 170 171 172 173 174 175 176 177 ... 243 244

Sin comentarios

DOD SR400D Especificaciones Pagina 172