DOD SR400D Especificaciones descargar pdf (Pagina 125)

117

 21. Open the inline flow valve to the hose reel. One is

located on the left side of the pump and the other is

on the right, at the front of the spray tank.

 22 Point the gun at the intended target area and pull

the trigger. Adjust spray pattern as needed.

TERMINATING PROCEDURES

 23. Discontinue spraying by releasing the trigger on

spray gun.

 24. Open the pressure relief valve by releasing the wire

clip on the Pressure Control Unit.

 25. Drain the pesticide into a holding tank by way of the

drainpipe located at the rear of the sprayer below

the pump. The drainpipe is attached to the frame.

CLEANING PROCEDURES:

 26. Refill the tank with at least 10 gallons of water and

add liquid detergent.

 27. Re-pressurize the entire system. Flush out the spray

hose, gun, and nozzle.

 28. Open the pressure relief valve after all cleaning

solution is used up. Drain all lines. Close all in-line

valves.

 29. Wind up the hose and secure the spray gun.

1 2 ... 120 121 122 123 124 125 126 127 128 129 130 ... 243 244

Sin comentarios

DOD SR400D Especificaciones Pagina 125